DIY5 device: Add smart notifications to your project using four continuity and one voltage sensor: short one lead of the continuity sensor to the ground and get an alert.  Apply DC voltage between 0.5 VDC and 50 VDC and get an alert. This alert can be an email (up to 5 email addresses are supported) or a push notification. We support Pushover and Pushbullet for push notifications.

This is the first MySpool device that features all stateful sensors:  every sensor, continuity, and voltage has a corresponding REVERT sensor, which sends an alert when the sensor state changes back to normal.

Free SMS notifications can be set up using an email-to-SMS gateway. See instructions here.

If you require native text (SMS) notifications, you can purchase a Professional Alert with 1000 SMS alerts.

INCLUDED:  DIY5 electronics in a rugged enclosure and an A/C power cable.

Free Shipping

• Wireless alert at over 200 feet; 2.4GHz WiFi is required. Email and text message notifications are sent when continuity sensors are shorted to the ground or 0.5-50 VDC is applied to the voltage sensor. 
• All sensors are configured independently with custom messages, email text, and addresses. Alerts are sent repeatedly, with configurable intervals.  Each sensor has a corresponding OFF sensor: when the state is reverted, its OFF sensor sends one REVERTED alert. The configuration web page shows 10 independently managed sensors that can be disabled if not required.
• The rugged enclosure supports up to 250 lbs and is designed to operate in dusty and moldy environments. Use the green screw terminals for continuity sensors, the onboard screw marked with V+ for the DC voltage sensor, and the onboard screw for common ground for all sensors marked with -.
• You are in control:  you can change the text of the alert or email message and add or remove email addresses—up to 5 are available for each sensor.