Sensors

Please note: most of our devices are sent out for packing and fulfillment from multiple warehouses while these sensors and spare parts are fulfilled from a small one. Each is serviced by a separate shopping cart because different teams fulfill these orders. To purchase these sensors please place a separate order and do not add any devices to it. We carry spare sensors as a courtesy to our customers and have thus far been unwilling to discontinue selling them.


 

 

 

Contents: Replacement Sensor for External Mailbox Alert 
Wire length: 36 inches  


 

 

 

Use this push button switch as a replacement sensor for Mailbox Alert.  It can be used in heavy-duty metal mailboxes or in custom boxes where magnetic sensors do not work or are hard to install.  This switch must be deployed in depressed position to send an alert when the door opens and the button is released.

 

Contents: Replacement Sensor for External Mailbox Alert 
Wire length: 36 inches  


 

 

 

Contents: replacement sensors for WATER Alert. Package of 2. Wire length: 27 inches


 

 

 

This is a Float Sensor for DIY products. It can also be used in  MySpool Water Alert editions when plugged into the Water Sensor blue circuit board. This Float Sensor comes with a 3 ft updated 5 ft Wire with JST connector which is mated with the white 2 pin DIY JST connector.  

The float sensor can be used to detect high or low water levels. The default setting detects high water levels.

To deploy, mount it vertically with wires facing up. When the float rises to the black o-ring, it completes the connection and causes DIY boards and Water Alert devices to send an alert.  

If you need to detect a low water level condition, take the float ring off the shaft, flip it upside down, and put it back on the shaft. The alert will then be sent when the float drops with the falling water level.

 

Contents: 1 Float Sensor for MySpool devices.
Wire length: 60 inches 


 

 

Listing is for the Bracket Only – Float Sensor is shown as an illustration
Float Bracket is sized for M10 screws, please check your float sensor before ordering
Easily mounted on a pipe with a cable tie

Simple and reliable, this stainless steel bracket works best with a 10mm float sensor.
It can be easily mounted on a pipe with a cable tie.
Overall Height is 25mm
Mounting Slot is 10mm

 


 

 

 

This is a rugged replacement sensor for all MySpool Water Alert editions. Rugged Sensor comes with a 5 ft Wire which is rigidly connected to the nickel-plated sensor pad.

Contents: 1 rugged sensor for MySpool devices.
Wire length: 60 inches


 

 

 

This is a rugged replacement sensor for all MySpool Water Alert editions. Rugged Sensor comes with a 10 ft Wire which is rigidly connected to the nickel-plated sensor pad.

Contents: 1 rugged sensor for MySpool devices.
Wire length: 120 inches


 

 

 

This is a waterproof Temperature sensor for MySpool Water and Temperature Alert. It comes with a white connector.

The one with a black connector is used with the Multi-Sensor DIY board.

Please specify which one you require when you place your order.

Contents: 1 temperature sensor for MySpool devices.
Cable length: 36 inches