Connect your device to WiFi

 

  1. Step 1 Activate your device:

    • CALLME Button: Press and hold the button for 2 seconds. 
    • Alert Button: Twist clockwise to reset. Press down. 
    • MAILBOX Alert: Separate the sensor parts for 2 seconds by two inches or more. 
    • MAILBOX Alert Extended Range: plug your hub in an A/C outlet
    • WATER Alert: Plug it in. Dip the sensor pad in a cup of water for 30 seconds. Wipe it dry.
    • WATER Alert With Float Sensor: bring the float all the way up for 2 seconds.
    • Extended Range Hub: Plug it in.
    • POWER Alert: Plug it in. 
    • Plugin Water Level Alert: Plug it in.
    • A/C powered voltage monitor: Plug it in.
    • Internet Outage Detector: Plug it in.
    • Temperature Alert: Plug it in.

     

    Open your phone, go to Settings, and choose Wi-Fi.  Under the CHOOSE A NETWORK tab you will see available networks. One of them will be your device. It will look like SASensor-000000 where "000000" is the unique device ID. In the example on the right it is shown as SASensor-2336877. It may take up to 30 seconds for the SAS network to become visible on your phone or a laptop.

     

    Write down your device ID and provide it when contacting myspool support.

     

     

  2. Step 2 Select SASensor-000000. Once connection is established, which may take 10-15 seconds, it will open a browser window with WiFi Manager. Please note, in case you do not see the WiFi Manager page, you may need to open a browser window and type in an address: 10.10.4.1 . The window will look like this:

    See Note below if you are having problems with this step

    If you have an Android phone and are unable to connect, please see this.

     

     

  3. Step 3 Click Configure WiFI, you should see the configuration window:

     

  4. Select your WiFi router and enter it’s password. Please note that some phones will CAPITALIZE the first letter. Make sure your password is entered correctly!

     

  5. Press Save, and return the phone to it’s old WiFI network. Make sure that you see "Credentials Saved" on your phone. Otherwise you may need to perform this configuration process again.

 

Important:  when your device has successfully connected to your WiFi network, SAS network will no longer be visible on your phone. It is present only for the WiFi setup.

 

Note: if you can connect to the SAS network but do not see the WiFi Manager configuration menu, you may need to open a web page at 10.10.4.1.  If that page does not open, disconnect from SAS network by going back to Settings and selecting your Home WiFi network. Wait for 5 seconds and re-connect to SAS network. Sometimes it helps to go back to Settings, then click on WiFi again to re-connect.

You may also need to go back to Settings, and connect to your Home WiFi in case you are unable to establish connection with SAS network. This will force your phone to drop the connection and establish a new one. Then connect to SAS network and proceed with WiFi configuration.