Buy Now

$39.99
  • Instant emergency alert with no hidden fees
  • Get help at the push of a button: send a text message and an email instantly
  • Built-in transmitter uses your WiFi to communicate with cloud-based servers
  • 3 AAA batteries are included
  • A CALLME button sends a text message or an email or both using your WiFi. The setup takes a few minutes with a smart phone or a laptop and requires a valid email address and a phone number. You can specify hours of operation or disable your CALLME button if needed. You can also specify email and text message content.

    $25.00

    This circuit board plus the included processor with our code is all you need to make a Smart Sensor:  short the pins on the white connector and you will get an alert! 
     
    Use your imagination and our portal to configure your custom device!  
    Note 1: your device is configured as SENSOR. Refer to CALLME Button FAQ for documentation on how to configure your device. Press the 'sensor' button or short the two pins of the white connector to activate your device. 
    Note 2: only email and pushbullet alert notifications are supported.  3 AAA batteries required, not included.
     
    Free Shipping

    Sensor Configuration Overview
    Register a user ID for yourself: use Registration Code on the enclosed card and Create an Account   Then you will be able to Register New Device and Configure Device.  Be sure to add your email address and CONFIRM your email when you receive an email confirmation request. After that you will need to tell your Sensor how to use your WiFi - follow the directions for the CALLME Button setup.   You Activate your sensor by pressing a 'Sensor' button or shorting wires connected to the white pin header. We hope that you find this device useful and share with us your application of it.
      

    $69.99

    We took an advanced Gas Sensor and added our secret sauce: we made it into a Smart Gas Alert. Myspool Gas Alert gives you all the functionality of a first rate Gas Sensor: it detects explosive gases such as natural gas (methane) and LPG (propane). It sounds a loud alarm, has a display that shows detected gas concentration, and has been extensively tested.
     
    Like all MySpool devices, Gas Alert is also a smart device that sends out an alert when Gas is detected by its sensor. That alert is a message, either via email or text, or both. Optionally, this device can also send you pushbullet notifications. Gas Alert is configured to use your WiFi. The setup takes a few minutes with a smart phone or a laptop. 
     
    There are no fees for using Myspool Gas Alert for any kind of alert notifications. One requirement for the Gas Alert location is that a WiFi network is available to access Myspool cloud servers.

    $129.99
  • Wireless alert at over 1200 feet; WiFi required for the HUB
  • Email and text message notification when you get mail
  • Easy installation and configuration: you choose when the alert is active
  • Uses 3 AAA batteries, included
  •  
    Turn your mailbox into a SmartMailbox: get a text message and an email when your mailbox door is opened. Save a trip to check your mail in bad weather. Requires WiFi within 200 ft of the HUB. Installation required.
    This set includes a Mailbox Alert Node and a MySpool HUB. The Node and the HUB communicate over the air. The HUB requires WiFi to send alerts to MySpool cloud servers. This combination greatly increases the range of the standard MySpool Mailbox Alert which uses WiFi and does not require a MySpool HUB. Our tests have shown reliable alerts sent at 400 feet by a standard MySpool  Mailbox Alert and at 1600 feet by the Mailbox Alert Extended Range Set, both at line of sight. 

    $49.99
  • Wireless alert at over 400 feet; WiFi required
  • Email and text message notification when you get mail
  • Easy installation and configuration: you choose when the alert is active
  • Uses 3 AAA batteries, included
  •  
    Turn your mailbox into a SmartMailbox: get a text message and an email when your mailbox door is opened. Save a trip to check your mail in bad weather. Requires WiFi within 400 ft of the mailbox. Installation required.

    $49.99
  • Wireless alert at over 400 feet; WiFi required
  • Email and text message notification when you get mail
  • Easy installation and configuration: you choose when the alert is active
  • Uses 3 AAA batteries, included
  • NOT FOR USE INSIDE METAL MAILBOXES
  •  
    Turn your mailbox into a SmartMailbox: get a text message and an email when your mailbox door is opened. Save a trip to check your mail in bad weather. Requires WiFi within 400 ft of the mailbox. Installation required.

    $10.00

    Replacement Sensor for External Mailbox Alert
    Wire length: 36 inches
      
    Free Shipping
      
      

    $9.00

    Replacement Sensor for Internal Mailbox Alert
    Wire length: 4 inches
      
    Free Shipping
      
      

    $39.99
  • Be Alerted of Leaks while away from home or business: MySpool Water Alert uses Wi-Fi to send text messages, email or push alerts when water is detected
  • Name each Water Alert during set up and send notifications to identify the source of the leak
  • Each MySpool Water Alert is independent; no hub is required
  • WiFi access at the Water Alert location is required, please check before ordering
  •  
    Be Alerted of Leaks While away from Home or Business MySpool Water Alert is a smart water sensor that sends email, text, and smartphone alerts to homeowners, renters, business owners, and property managers as soon as a water leak is detected. Avoid costly repairs by keeping the Water Alert anywhere that has the potential for flooding or developing a leak.
     
    No Hub Required With Myspool Water Alert you avoid the limitations of other hub-based and wired products. Each Water Alert works independently with your Wi-Fi network. The Water Alert can be placed in multiple locations throughout your home or business. Your notifications will include your text for each Water Alert that you specify in the device configuration. Name your location and place it near sinks, refrigerators, washers, sump pumps and in basements.
     
    No Fees There are no fees for using Myspool Water Detector for any kind of alert notifications.
     
    Flexible design Myspool Water Alert comes with an extra long 6 foot power cord connected to an enclosure with a transmitter. The enclosure can be placed on a shelf, mounted on any smooth surface with included double sided pads, or simply left on the floor. The actual water sensor is nickel plated to resist oxidation. It is connected to the enclosure with a set of wires over 2 feet long. This allows the sensor to be placed in hard to reach places, including a crawl space or a sump pump bucket. The only requirement for the Water Alert location is that a WiFi network is available to access Myspool cloud servers.
     
    A must-have For renters, homeowners, property managers, and business owners everywhere, the Water Alert is a must-have device, saving you thousands of dollars in damage and costly repairs. Avoid the hassle and headache and get your Water Alert today.